NONLINEAR LABS C15 - Page 64

Parameter Reference
Parameter Reference
126 127
Amount of modulation of the frequency fluctuation by
Envelope C. At zero, the modulation stays constant, at higher
values, the envelope applies a time-variant attenuation.
Start phase [in degrees]. The Oscillator will be set to this
phase position with each Note-On.
Amount of phase modulation by Oscillator & Shaper A (local
feedback).
Envelope (A) amount for the phase modulation by Oscillator
& Shaper A (local feedback).
At zero, the modulation stays constant, at higher values, the
envelope applies a time-variant attenuation.
Mix amount of Shaper A in the signal being used for phase
modulation (self). At zero, the output signal of Oscillator
A is used. At negative values, the signal from the Shaper is
inverted.
Amount of phase modulation by Oscillator & Shaper B (cross
feedback).
Oscillator A
Key tracking of the envelope’s peak, breakpoint and sustain
levels [dB per semitone].
Positive values: higher levels for higher notes (+1.0 = +12 dB
per octave).
Negative values: lower levels for higher notes (-1.0 = -12 dB
per octave).
Origin at C3 = 60 semitones.
Key tracking of the attack, decay and release times. The
value determines how much shorter the times get for higher
notes.
Pitch (logarithmic frequency) of Oscillator A at C3 (MIDI note
60) [in semitones, based on MIDI note numbers].
The range below zero is shaped in the way that -20 corre-
sponds to 0 Hz.
Amount of pitch modulation by Envelope C [in semitones].
Key tracking of the oscillator pitch. It’s the scaling factor
between the key position (relative to C3 = 60 semitones) and
the pitch of the oscillator. At 100.0 %, the pitch follows the
equal-tempered scale. At values slightly larger than 100.0 %,
the tuning will be stretched. At 50.0 %, a quartertone scale
emerges and at 0.0 %, the pitch is constant for all keys.
Fluctuation of the oscillator frequency.
If the parameter is set larger than 0.0 %, the frequency is
changed at the beginning of each oscillation period by
a random amount. At 100.0 %, the maximum frequency
variation is +/- 95 %.
Oscillator A
Oscillator A