NONLINEAR LABS C15 - Page 74

Parameter Reference
Parameter Reference
146 147
Sets the ratio between the delay times of the le and of the
right channel [the value shows the oset to 100.0 %]. In the
center position, the oset is zero and both delay times are
equal.
Amount of internal feedback.
Amount of the cross feedback between the le and right
channel.
0.0 %: no cross feedback
100.0 %: all feedback is cross feedback
Cuto frequency [in semitones] of the filter that damps the
higher frequencies of the delayed signal.
Crossfades between the dry signal and the delayed signal.
The room size and reverb time are set here.
Reverb
Reverb
Sets the dierence between the center frequencies of the le
and of the right channel [in semitones].
Oset between the cutos of the lowpass and the highpass
[in semitones]. Since the two filters are running in parallel
and their output signals are mixed, the result of a positive
gap is a band rejection. With a negative gap, the pass bands
are overlapping so that all frequencies can pass and the
resonances emphasize the cuto frequencies.
Balance between the levels of the ranges above and below
the gap.
In the center position both ranges are equally weighted.
Negative values boost the lower range and attenuate the
higher range, positive values have the opposite eect.
Resonance of both filters. Higher values create two reso-
nance peaks at the upper and lower end of the gap.
Crossfades between the dry signal and the filtered signal. At
positive values, the filter runs in parallel (band reject) mode,
at negative values, it is a bandpass filter (in serial mode).
Mean delay time [in milliseconds]. (As there can be an oset
between the le and right channel, this control shows the
mean time.)
Echo
Echo