NONLINEAR LABS C15 - Page 76

Parameter Reference
Parameter Reference
150 151
Hardware Amounts
Hardware Sources
This control is the parameter representation of the “Bender”
Hardware Source. It will directly follow the Bender.
This control is the parameter representation of the “Aer-
touch” Hardware Source. It will directly follow Aertouch
gestures.
This control is the parameter representation of the “Ribbon
1” Hardware Source. It will directly follow the Ribbon and
vice versa. If the source’s return behavior is set to “Center”,
the parameter will be bipolar.
This control is the parameter representation of the “Ribbon
2” Hardware Source. It will directly follow the Ribbon and
vice versa. If the source’s return behavior is set to “Center”,
the parameter will be bipolar.
This control is the parameter representation of the “Pedal
1” Hardware Source. If a pedal is connected, it will directly
follow the external control. If the source’s return behavior is
set to “Center”, the parameter will be bipolar.
This control is the parameter representation of the “Pedal
2” Hardware Source. If a pedal is connected, it will directly
follow the external control. If the source’s return behavior is
set to “Center”, the parameter will be bipolar.
This control is the parameter representation of the “Pedal
3” Hardware Source. If a pedal is connected, it will directly
follow the external control. If the source’s return behavior is
set to “Center”, the parameter will be bipolar.
This control is the parameter representation of the “Pedal
4” Hardware Source. If a pedal is connected, it will directly
follow the external control. If the source’s return behavior is
set to “Center”, the parameter will be bipolar.
Hardware Sources
Determines the influence of the “Pedal 1” Hardware Source
on Macro Control A.
If the Pedal is a returning Hardware Source, the amount can
be adjusted continuously, otherwise it will be switch-like.
Continuous amounts can be set [in percent] and can cover
the whole range of the Macro Control in both directions
(-100.0 % … 100.0 %).
Determines the influence of the “Pedal 1” Hardware Source
on Macro Control B. If the Pedal is a returning Hardware
Source, the amount can be adjusted continuously, otherwise
it will be switch-like. Continuous amounts can be set [in
percent] and can cover the whole range of the Macro Control
in both directions (-100.0 % … 100.0 %).
Determines the influence of the “Pedal 1” Hardware Source
on Macro Control C. If the Pedal is a returning Hardware
Source, the amount can be adjusted continuously, otherwise
it will be switch-like. Continuous amounts can be set [in
percent] and can cover the whole range of the Macro Control
in both directions (-100.0 % ... 100.0 %).
Determines the influence of the “Pedal 1” Hardware Source
on Macro Control D. If the Pedal is a returning Hardware
Source, the amount can be adjusted continuously, otherwise
it will be switch-like. Continuous amounts can be set [in
percent] and can cover the whole range of the Macro Control
in both directions (-100.0 % … 100.0 %).
Hardware Amounts