Nord Drivesystems NORDAC LINK SK 155E-FDS - Field Distribution System Type Code; Version with Protection Class IP65

1 General
BU 0155 en-3520 25
1.7.2 Field Distribution System type code
SK 175E-FDS-301-340-A-XXX
Equipment code (multiple statements possible)
Radio interference filter: A = Class A
Mains voltage: x40 = 400 V
Number of mains phases: 3xx = 3-phase
Digits before decimal point for power: 0 = 0.xx, 1 = 0x.x0
Device rated power: 111 = 1.1 kW, 301 = 3.0 kW
Device series:
SK 155E-FDS, SK 175E-FDS
Configuration code
Meaning
-AS-i Actuator-sensor interface with “AS-i” connector option
-ASS
Actuator-sensor interface with “ASS” connector option
-AUX
Actuator-sensor interface with “AUX” connector option
-AXS
Actuator-sensor interface with “AXS” connector option
-BWRN
Integrated brake rectifier for controlling a 205 V DC brake
-HVS
Integrated 24 V DC power supply unit
-HWR
Integrated brake rectifier for controlling a 180 V DC brake
-PBR
Profibus interface
-TIDIO
With the aid of the -TIDIO option, the digital IOs of the motor starter are connected to the
corresponding IOs of an SK CU4 module in the device.
-USB RS232/RS485 interface: USB port in place of the RJ12 port.
Note: Parameterisation units cannot be connected to the USB port. Parameterisation and
diagnosis are only possible via a PC with NORDCON software.
1.8 Version with protection class IP65
The motor starter of the field distributor series SK 1x5E-FDS meets the following IP protection class:
• IP65
Information
Cable laying
Make sure that the cables and cable glands comply at least with the devices protection class and the
mounting regulations, and are carefully matched to each other.