Nord Drivesystems NORDAC LINK SK 155E-FDS - Description of Parameters; Figure 3: Explanation of Parameter Description

NORDAC LINK (SK 155E-FDS / SK 175E-FDS) – Users Manual for Motor Starters as Field Distributors
74 BU 0155 en-3520
5.2 Description of parameters
P000 (parameter number) Operating display (parameter name) xx
1)
S P
Setting range
(or display range)
Display of typical display format (e.g. (bin =
binary) of possible setting range and number
of decimal places
Other applicable
parameters:
List of other directly related
parameters
Arrays
[-01]
If parameters have a substructure in several arrays, this is shown here.
Factory setting
{ 0 }
Typical default setting of parameters in the as-delivered condition of the FI, or to which it is set after
carrying out "Restore factory settings" (see parameter P523).
Scope of Application
List of variants for which this parameter applies. If the parameter is generally valid, i.e. for the entire model
series, this line is omitted.
Description
Description, function, meaning and similar for this parameter.
Note
Additional notes about this parameter
Setting values
(or display values)
List of possible settings with description of their respective functions
1) xx = Other codes
Figure 3: Explanation of parameter description
Information
Unused lines of information are not listed.
Note / Explanation:
Code Designation Meaning
S
Supervisor-Parameter
The parameter can now be displayed and modified if the
relevant supervisor code has been set (see parameter
P003).
P
Parameter set-dependent
The parameter provides different setting options that are
dependent upon the selected parameter set.
RD
READ
Parameter can only be read.
RM
RAM
The parameter can be modified but not stored in the Flash
memory.
RF
READ/FLASH According to the setting of parameter
P130
, the parameter
can either only be read or can be changed and saved in the
flash memory.
FL
FLASH
The parameter is read out of the flash memory and can be
changed.