5 Parameter
BU 0155 en-3520 89
5.2.7 Information
P700 Current operating status RD
Current active error message (not acknowledged)
Current existing warning
block
Current existing reason for an active switch-on block
Display of current messages about operating status
Section 6 "Operating status messages"
P707 Software version
0.0 … 9999.0
Version number (e.g.: V1.0)
Revision number (e.g.: R1)
Special version of hardware/software (e.g. 0.0). The value “0”
means “Standard version”.
Display of software version (firmware version) of device
P708 Digital input status. RD
0000 0000 0000 … 0111 1111 1111
(bin)
(hex)
Display of switching status of the digital inputs
Value (Bit) Meaning
Switching status of digital input 1
Switching status of digital input 2
2 Digital input 3
Switching status of digital input 3
3 PTC input
PTC resistor input switching status
Signal status Bus In Bit 0
Signal status Bus In Bit 1
6 Bus In Bit 2
Signal status Bus In Bit 2
7 Bus In Bit 3
Signal status Bus In Bit 3
Switching status of Bus digital input 1
Switching status of Bus digital input 2
10 STO input
Signal status STO input
P709 Potentiometer status RD
[-01] = DIP switch S1
Actual value in % of 3.6 A (SK 1xxE-FDS-151-…), or
Actual value in % of 7.5 A (SK 1xxE-FDS-301-…)
Actual value in % of 25.6 s
Current value in % of 100 % start voltage
Current value in % of 25.6 s
Display of the set values of DIP switch S1 or potentiometer P1 … P3,
relative to
particular end values of the scale (in %)
To Next Page
Loading...