Nord Drivesystems NORDAC LINK SK 155E-FDS - Configuration Versions; Configurable Options

NORDAC LINK (SK 155E-FDS / SK 175E-FDS) – Users Manual for Motor Starters as Field Distributors
30 BU 0155 en-3520
2.2.2 Configuration versions
The device offers various interfaces in the form of plug connections. This makes it possible to
configure the device according to the individual requirements on the drive task.
The arrangement of the interfaces on the device is different depending on the device configuration.
One option slot has exactly one option type.
The following tables show which features can be combined and the influence they have on the
respective option slots.
Furthermore, using initiators or actuators allows for reading the related parameters and the valid
factory settings.
2.2.2.1 Configurable options
The following integrated features can be configured. Selection of the options must be made when the
frequency inverter is ordered. Subsequent changes to the configuration are not possible.
Meaning
-AS-i
Actuator-sensor interface with “AS-i” connector option
-ASS
Actuator-sensor interface with “ASS” connector option
-AUX
Actuator-sensor interface with “AUX” connector option
-AXS
Actuator-sensor interface with “AXS” connector option
-BWRN
Integrated brake rectifier for controlling a 205 V DC brake
-HVS
Integrated 24 V DC power supply unit
-HWR
Integrated brake rectifier for controlling a 180 V DC brake
-PBR
Profibus interface
-TIDIO
With the aid of the -TIDIO option, the digital IOs of the motor starter are connected to the
corresponding IOs of an SK CU4 module in the device.
-USB
RS232/RS485 interface: USB port in place of the RJ12 port.
Note: Parameterisation units cannot be connected to the USB port. Parameterisation and
diagnosis are only possible via a PC with NORDCON software.