OLED User Interface
119
Part 1128351_02
E 2020 Nordson Corporation
Troubleshooting Heated Zone Alerts and Faults (contd)
S Select Event Log to view all melter events (alerts, faults, parameter
changes, etc.) in the order they occurred, with the most recent on top.
S Refer to the Troubleshooting section for more information.
Fault
3
1
2
4
No RTD/heater current is detected for zone 2.
Item Description
1
Type of alarm generated. This can be an Alert, Fault, or
Stop.
2 Date and time stamp when the event occurred. Some
events occur quickly. Look at the seconds in the time stamp
for additional troubleshooting.
3 Opens the Event Log, with the newest event displayed first.
NOTE: Go to Tools | Reports/Logs to export the Event Log
to a USB
4 Acknowledges the message and removes the alert pop up
message from view. Although the condition still exists,
attention is needed. You can view the message again from
the Event Log.
To Next Page
Loading...
