Table of Contents
ii
Part 1128351_02
E 2020 Nordson Corporation
Safety Labels and Tags 11......................................
Basic Operations 13............................................
Additional Information 13..........................................
About the Home Screen 14........................................
Navigation Controls 14.........................................
Using the Master Controls 16......................................
About the System Status and LED Indicators 18......................
About the System Status Colors 20...............................
Common Operator Tasks 22......................................
Starting the Melter 23.............................................
Shutting Down the Melter 23....................................
Switching the Master Heater and Pump Controls On/Off 24.............
Monitoring the Tank Adhesive Level 25.............................
Manually Filling the Melter Tank 26................................
Manually Initiating the Automatic Fill System 27...................
Managing Heated Zones 28.......................................
Enabling/Disabling and Changing Zone Set Point Temperatures 28...
Managing System Air Pressure 31..................................
Manually Adjusting System Air Pressure 31........................
Electronically Adjusting System Air Pressure 32....................
Defining Manual and Electronic Pressure Monitor and Adjust Settings 33
Defining Manual Pressure Adjust Alert Settings 33..................
Defining Electronic Pressure Settings and Monitoring Alert Settings 34
Electronic Pressure Alert and Monitoring 34.....................
Electronic Pressure Control Settings 35.........................
Defining Pressure Runup Settings and Monitoring Alert Settings 36...
Pressure Runup Output Settings 36............................
Pressure Runup Alert Threshold Settings 38.....................
Pressure Runup Pressure Limits 39............................
Pressure Runup General Settings 39...........................
About Loading and Saving a Recipe 40.............................
Loading a Recipe 42.........................................
Saving/ SaveAs a Recipe 42..................................
Viewing the Event Log 43.........................................
System Settings 44.............................................
Additional Information 44..........................................
Defining Tank-Only Level Sensing Settings 45.......................
Enabling/Disabling Low Level Alerts and Settings 45...............
Enabling/Disabling Empty Stop 46...............................
Enabling/Disabling Lid Open Alerts and Settings 47................
Defining Level and Fill Settings 48..................................
Melt-on-Demand and Tank Systems with Optional Fill Settings 48....
Maximum Fill Time and Target Fill Level Settings 48.............
Defining Temperature Settings 49..................................
Defining SmartMelt Settings 49..................................
Defining Setback Settings 50....................................
Manually Entering/Exiting Setback 50.............................
Defining Automatic System Setback 51...........................
Defining Manual Setback - Auto Exit Time 52......................
Defining Ready Delay 53........................................
Bypassing Ready Delay 53...................................
Defining Global Temperature Settings 54
..........................
Enabling/Disabling Heaters On Upon Startup 54....................
Defining the Over/Under Temperature Thresholds 55...............
Defining Temperature Setback 55................................
To Next Page
Loading...
