ValveMate 7197PCP-2K Controller
14 www.nordsonefd.com info@nordsonefd.com +1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
Install the 797PCP-2K Pumps
For pump installation instructions, refer to the 797PCP-2K manual.
Install the Ancillary System Components
NOTE: Refer to “Installation Example” on page19 for system layout images of typical installations.
Install any system components (other than the controller and pumps) that will comprise the complete dispensing
system. For example, if you are using a fluid reservoir, position and install all the fluid reservoir components. For all
ancillary components, refer to the quick start guide and / or operating manual provided with those components for
installation and setup instructions.
Installation (continued)
Connect the Foot Pedal
Connect the foot pedal to the food pedal port on the back of
the controller.
NOTE: An alternative to the foot pedal is a 24 VDC dispense
cycle initiate signal connected to the I/O port. To use this
option, you will need to remove the ESTOP jumper and then
make the correct connections to the I/O port. Nordson EFD
recommends using a breakout board and cable to connect
wiring to the I/O port. Refer to “I/O Port Pin Assignments and
Wiring Diagrams” on page44 for wiring details. Contact
your Nordson EFD representative for assistance in obtaining
a breakout board and cable.
7014865
Connect the ESTOP Jumper
Connect the supplied ESTOP jumper to the I/O port on the
back on the controller.
This jumper creates an ESTOP circuit. The pump will
dispense only if the ESTOP pins (Estop_H and Estop_L) are
connected. Refer to “I/O Port Pin Assignments and Wiring
Diagrams” on page44 for wiring details.
ESTOP
jumper
To Next Page
Loading...
