Nordson ValveMate 7197PCP-2K - Programming (continued); Creating Programs Overview

27www.nordsonefd.com info@nordsonefd.com +1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
ValveMate 7197PCP-2K Controller
Programming (continued)
Creating Programs
The controller allows you to create five types of program: Line, Volume, Weight, Teach, and Timed. A general
programming procedure is provided on the next page. Specific programming procedures, including detailed
information on all settings, are provided in the sections shown under “Detailed Information.”
Program
Type
Description Typical Application Detailed Information
Line Use a Line program to dispense material
continuously, for as long as the dispense
cycle is activated.
Continuous lines, all
viscosities
Refer to “Line Programs”
on page29.
Volume Use a Volume program to dispense a
specified amount of material in milliliters.
Filling a known volume Refer to “Volume
Programs” on page30.
Weight Use a Weight program to dispense a
specified amount of material in grams.
Dispensing based on
weight
Refer to “Weight Programs”
on page31.
Teach Use Teach program to “Teach” the system
the desired dispense time and volume.
Filling an unknown
volume
Refer to “Teach Programs”
on page32.
Timed Use a Timed program to dispense for a
specified amount of time, in milliseconds per
cycle.
Dispensing for a
known period of time
Refer to “Timed Programs”
on page33.
On the web interface, all
program type buttons are on
the Home screen
ValveMate 7197PCP-2K Touchscreen 7197PCP-2K Web
Variable table: The content
of this table changes
based on the selected
program / variables. The
settings for both pumps
are shown side by side.
On the touchscreen interface,
all program type buttons are on
the Programs screen