Nordson ValveMate 7197PCP-2K - Connect a Purge Initiate Signal (Optional); Make the Ethernet Connection (Optional)

ValveMate 7197PCP-2K Controller
16 www.nordsonefd.com info@nordsonefd.com +1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
Installation (continued)
Connect a Purge Initiate Signal (Optional)
If you want to connect an external purge initiate, you will need to remove the ESTOP jumper and then make the
appropriate connections to the I/O port. Nordson EFD recommends using a breakout board and DB-15 cable to
make these connections.
• Contact your Nordson EFD representative for assistance in obtaining a breakout board and cable.
• Refer to “I/O Port Pin Assignments and Wiring Diagrams” on page44 for wiring details.
Make the Ethernet Connection (Optional)
An Ethernet cable can be connected to the ValveMate 7197PCP-2K Controller to support factory integration and
firmware updates. Make the Ethernet connection as applicable for your system.
To access the optional 7197PCP web interface:
Making an Ethernet connection allows you to also control the system via a web interface. After the Ethernet
connection is made, open a web browser (Chrome or Firefox are preferred) and go to the following URL:
http://192.168.10.51:8088/Iface.php.
NOTE: A ValveMate 7197PCP-2K Controller’s preprogrammed IP address is 192.168.10.51. If there are multiple
ValveMate 7197PCP-2K Controllers on the same network, they each need a unique IP address:
• To change the IP address of a ValveMate 7197PCP-2K Controller, refer to “Changing the IP Address of the
Controller” on page37.
• To change the IP address of a computer, refer to “Appendix A, Changing the IP Address of a Computer” on
page49.
Category 5e
Ethernet cable
Ethernet
switch
Making the Ethernet connection between the
ValveMate 7197PCP-2K and a computer
Category 5e
Ethernet cable