Nordson ValveMate 7197PCP-2K - Adjusting the Purge Speed Setting

ValveMate 7197PCP-2K Controller
26 www.nordsonefd.com info@nordsonefd.com +1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
Variable Range Description
RPM 10–150 (RPM) Sets the purge motor speed in RPM; for guidance on setting the RPM,
refer to “Maximum Motor Speed Based on Viscosity” on page47.
Info n/a Select to view information about the current screen, including the range
limits for settings.
Adjusting the Purge Speed Setting
Before placing the system into operation, or anytime that purging is required, refer to the purging procedures earlier
in this manual. Use this procedure only to change the purge RPM, ensuring that the maximum allowable motor
speed is not exceeded. Refer to “Maximum Motor Speed Based on Viscosity” on page47.
1. On the Main screen, select PURGE.
2. On the touchscreen interface: Select the UPDATE PURGE PUMP radio button for the pump you want to purge.
On the web interface: Select the UPDATE PURGE radio button.
3. Enter the desired RPM setting, ensuring that the maximum allowable motor speed is not exceeded. Refer to
“Maximum Motor Speed Based on Viscosity” on page47.
NOTE: Values must be within the specified range limits, or they will not save.
4. Select SUBMIT. The Purge RPM speed updates.
NOTE: On the web interface, the system returns to the Home screen after a purge RPM update.
Programming (continued)
Purge screen, touchscreen interface
Purge screen, web interface
ValveMate 7197PCP-2K Touchscreen 7197PCP-2K Web
1
2
3
1
2
3
4
4