Nordson ValveMate 7197PCP-2K - Technical Data (continued); Maximum Motor Speed Based on Viscosity

47www.nordsonefd.com info@nordsonefd.com +1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
ValveMate 7197PCP-2K Controller
Maximum Motor Speed Based on Viscosity
Based on the viscosity of the dispensing material, ensure that the motor speed does not exceed the maximum RPM
shown in the table and graph below.
Example: If the dispensing material has a viscosity of 8,000 mPa s, the RPM setting should be no higher than
135RPM (90% of the allowable maximum setting of 150 RPM).
Viscosity Percentage of Maximum RPM
1–800 mPa s 100%
800–10,000 mPa s 90%
10,000–25,000 mPa s 70%
25,000–50,000 mPa s 50%
50,000–150,000 mPa s 25%
Viscosity RPM
1000 150
5000 140
7500 135
10000 125
12500 120
15000 113
20000 107
30000 102
40000 95
50000 88
75000 72
100000 57
125000 45
150000 36
200000 22
250000 11
Viscosity in mPa s
Speed in RPM
Technical Data (continued)