Nordson ValveMate 7197PCP-2K - Operation; Routine Startup and Error Handling

ValveMate 7197PCP-2K Controller
38 www.nordsonefd.com info@nordsonefd.com +1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
Operation
After the dispensing system is fully installed and the desired dispensing programs are created, the system is ready
for routine operation. Follow these recommended procedures for daily / routine startup and shutdown to obtain the
best performance from your system.
Routine Startup
1. Switch on the power for all ValveMate 7197PCP-2K Controllers in
the system.
Risk of equipment damage. Do not operate a 797PCP-2K without
material. Excessive friction of dry components can damage the pump.
CAUTION
2. Create or load the program to run. To load a saved program, refer to “Opening a Saved Program (Load Screen)”
on page35.
3. Start your process.
When the system is operating normally, the status indication on the Main screen indicates “Running.”
NOTE: Refer to “Status Indications” on page22 for an explanation of all status indications provided on the
Main screen.
Errors and Emergency Stops (ESTOP)
If the status indication on the Main screen shows an error or emergency stop condition, check the Log screen
and correct the problem that caused the error or stop. Refer to “Viewing the Log” on page42 and to
“Troubleshooting” on page42.
Power switch