ValveMate 7197PCP-2K Controller
28 www.nordsonefd.com info@nordsonefd.com +1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
Creating Programs (continued)
Follow this general procedure to enter settings for a program. A task-specific procedure is also provided for each
program type later in this section.
1. (Touchscreen interface only) On the Main screen, select PROGRAMS.
2. Select any program type button to display the variables for that selection.
3. To view information about the currently displayed screen, select Info.
4. (Touchscreen interface only) Select the pump button to toggle between the Pump 1 and Pump 2 screens.
5. To enable a program, select the ENABLE [program type] PROGRAM radio button.
NOTE: If you don’t enable the program, the system will not save any entered settings.
6. Make the desired radio button selections and / or enter settings inside the value fields. Refer to the applicable
sections of this manual as noted in the table above for detailed information about each program type, including
setting ranges.
7. When all variables are at the desired setting, select SUBMIT. The system saves the settings and displays them
in the Variable table.
8. Select BACK (touchscreen interface) or REFRESH (web interface) to return to the Main screen.
9. To save the values you entered as a program in the Program Library, refer to “Saving a Program to the Program
Library (Save Screen)” on page34.
Programming (continued)
Example of general programming steps (Line program screen shown)
Line program screen, touchscreen interface
Line program screen, web interface
ValveMate 7197PCP-2K Touchscreen 7197PCP-2K Web
1
2
34
5
6
7
5
8
3
7
6
2
8
To Next Page
Loading...
