Nortel 7400 - CP Ethernet Cable Replacement Task Flow

128 Chapter 20 CP Ethernet cable replacement
NN10600-175 6.1S2
hub or IP router. See OAM Ethernet port sparing in NN10600-550 Nortel
Networks Multiservice Switch 7400/15000/20000 Common
Configuration Procedures.
CP Ethernet cable replacement task flow
This task flow shows you the sequence of procedures you do to replace a CP
Ethernet cable. To link to any procedure, go to
“Task flow navigation”
(page 129).
Figure 33
Ethernet cable replacement task flow
Active Standby
CP Ethernet cable
replacement
CP active or
standby?
Removing a CP
Ethernet cable
Installing a CP
Ethernet cable
End
Removing an
Ethernet cable
Installing an
Ethernet cable
Enabling CP
switchover for a
CP OAM Ethernet
port failure
Disabling CP
switchover for a
CP OAM Ethernet
port failure
PP_TASK_1022
For procedure page
numbers, see
Task flow navigation
below