480 Chapter 39 Hardware procedures
NN10600-175 6.1S2
Removing the shelf assembly of a Multiservice Switch 7460
Remove a n Nortel Networks Multiservice Switch 7460 if it has a bent or
broken backplane pin, or if there is a failed card slot.
Prerequisites
WARNING
Risk of injury
The shelf assembly weighs 18.9 kg (41.667 lb). You need
two people to perform this procedure.
WARNUNG
Verletzungsgefahr
Die Regalkomponente wiegt 18.9 kg. Zur Montage sind
zwei Personen erforderlich.
CAUTION
Risk of equipment damage
You need two people to remove a Multiservice
Switch
7460 from a rack or cabinet: one person must
hold the chassis in place while a second person
unfastens the screws.
CAUTION
Risk of damage to equipment by moving
When moving an uncrated cabinet or shelf assembly,
protect it from strain, shock, impact, and vibration. Lack
of protection can damage or warp the equipment.
To Next Page
