406 Chapter 39 Hardware procedures
NN10600-175 6.1S2
Removing a 13-inch termination panel from a Multiservice
Switch
7420
Remove a termination panel from a Nortel Networks Multiservice
Switch
7420 to replace a failed panel or if you are removing its associated
FP(s) from the shelf.
• “Procedure steps” on page 406
• “Procedure job aid” on page 407
Procedure steps
1 Label the cables connected to the termination panel. Then, remove the
cables and coil them carefully out of the way.
2 Remove the screws at the ends of the termination panel that hold the
panel in position. See the figure “Multiservice Switch 7420 termination
panel removal” (page 407).
3 Replace the screw that you removed in step 2.
To Next Page
