Chapter 39 Hardware procedures 545
Multiservice Switch 7400 Hardware Installation, Maintenance, and Upgrade 6.1S2
Unpacking and removing a seismic cabinet from a pallet
Unpack and remove a seismic cabinet in a dust-free area near the installation
site.
Procedure steps
1 Move the pallet close to where it is to be installed.
2 Remove and keep the packing slips and shipping papers attached to the
outside packaging.
3 Carefully cut the plastic stretch wrap around the cabinet.
4 Use a pair of tin snips to cut the banding that secures the cabinet
packaging.
5 Lower the ramp that is attached to the pallet as shown in “Lowering the
pallet ramp” (page 546).
WARNING
Risk of personal injury
The banding that secures the cabinet packaging is under
pressure and can fly up when cut.
WARNUNG
Verletzungsgefahr
Die Gehäuseverpackung ist mit einem Spannband
gesichert. Seien Sie vorsichtig beim Durchschneiden des
Bandes, da es möglicherweise mit Gewalt aufspringt.
To Next Page
Loading...
