Nortel 7400 - BITS Cable Replacement; BITS Cable Replacement Task Flow

99
Multiservice Switch 7400 Hardware Installation, Maintenance, and Upgrade 6.1S2
Chapter 12
BITS cable replacement
Replace a BITS cable on an CP if it is faulty or as part of a CP replacement
procedure.
Prerequisites to BITS cable replacement
• Have an appropriate replacement cable present before beginning the
procedure. For BITS cable product engineering codes (PECs) and
lengths, see NN10600-170 Nortel Networks Multiservice Switch 7400
Hardware Description.
• Some of the procedures in this task are not located in this document.
Ensure that you have access to the required documents.
BITS cable replacement task flow
This task flow shows you the sequence of procedures you do to replace a
BITS cable. To link to any procedure, go to
“Task flow navigation”
(page 100).