Chapter 39 Hardware procedures 537
Multiservice Switch 7400 Hardware Installation, Maintenance, and Upgrade 6.1S2
Procedure job aid
Table 19
Equipment checklist for unpacking a Multiservice Switch 7480
÷ Equipment
Device shelving (for 1 or 2 devices, depending on your installation)
Cooling unit chassis
Cooling unit and air filter
Cooling unit cables
Shelf assembly ground cables
Cable management assembly
Power supplies (up to 3)
Power supply filler (3 less the number of power supplies)
CPs (1 or 2)
FPs (up to 15)
FP cables (as required)
Blank processor cards (NTBP23), 14 for each device less the
number of processor cards
Termination panels (as required)
Grounding cable for termination panels
Grounding strips for termination panels (1 for each panel)
Power cords (1 for each power supply)
Power cord selector guide
Antistatic wrist strap
To Next Page
