Nortel M760 - Deleting, Modifying and Exiting Programming

Programmable keys
49
4 - Press the Enter interactive key to accept the programming.
The display shows the programming.
This way, you can enable or disable the filtering function
by simply pressing this key, as a function of your work.
Tone
Programming
a series of codes:
This involves programming a series of codes that will be
interpreted by the set during the progress of a call.
You can, for example, program the sequence for access
to your voicemail service.
1 - Press the Tone interactive key.
The display prompts you to enter the code.
2 - Enter the sequence.
Example: enter the number of the voice mailbox followed by #,
then your personal voicemail code followed by #.
. If you make a mistake, use the Erase interactive key.
. To insert a pause between two series of codes, press the
Pause1 or Pause2 interactive keys.
3 - Press the Enter interactive key to accept the programming.
The display shows the programming.
This way, simply pressing this key when using the set
during a call will provide you with all expected information
and will give you fast access to the expected service.
Enter
Enter
Mailbox no. # pswd #
Deleting, modifying and exiting programming
Erase
After having programmed a key, The display shows
the programming status of this key, and will give you various
possibilities.
- Press the Erase interactive key to erase the programming
shown.