Notifier LCD-160 User Manual

LCD-160 P/N 51850:A 09/26/2003 13
Installation
Installation Overview
1. Mount and ground the cabinet or backbox (Section 5.1).
2. Pull wiring into backbox (Figure 4).
3. Configure RDP bus ELR DIP switch (Figure 9).
4. Connect Earth Ground to a mounting screw on the backbox or cabinet (Section 6.3).
5. Mount the optional Annuciator Key Switch (Section 6.5).
If mounting into a CAB-4 series backbox: (Section 4)
6. Mount the LCD-160 to the dress panel (Figure 5).
7. Mount the dress panel to the backbox.
8. Make all electrical connections:
• RDP bus & shielding if necessary. (Figures 7 & 8)
• Power circuit (Figure 11)
9. Attach doors to backboxes (Section 5.2).
10. Power up system according to instructions in the control panel manual.
11. Configure the LCD-160 (Section 9.1).
If mounting into an ABS-2D/4D or ABF-2B/4B backbox: (Section 4)
6. Make all electrical connections:
• RDP bus & shielding if necessary. (Figures 7 & 8)
• Power circuit (Figure 11)
7. Mount the LCD-160 in the backbox.
8. Attach doors to backboxes (Section 5.2).
9. Power up system according to instructions in the control panel manual.
10. Configure the LCD-160 (Section 9.1).

Notifier LCD-160 Specifications

General

Brand	Notifier
Model	LCD-160
Category	Monitor
Language	English