Novatel OEM7 - Page 4

OEM7®Installation and OperationUser Manual
OEM7 Installation and Operation User Manual v1 4
2.8 Preparing the Data, Signal and Power Interface 27
2.9 Mounting the GNSS Antenna 31
2.10 Connecting the Antenna to the Receiver Card 32
2.10.1 Antenna LNA Power 32
2.11 Applying Power to the Receiver Card 33
2.12 Connecting Data Communications Equipment 33
2.12.1 Serial Ports 33
OEM719Multiplexed Port 34
OEM729 RS-422 Port 35
OEM729 Multiplexed Port 35
OEM7700 Multiplexed Port 36
2.12.2 USB Ports 36
2.12.3 Ethernet Ports 38
2.12.4 SPI Ports 38
2.13 Test that the Receiver is Working 39
2.14 Installing NovAtel PC Utilities 39
Chapter 3 OEM7 Receiver Operation
3.1 Communications with the Receiver 41
3.1.1 Serial Ports 41
3.1.2 Communicating using a Remote Terminal 42
3.1.3 Communicating using a Computer 43
3.2 Getting Started 43
3.2.1 Starting the Receiver 43
3.2.2 Communicating with the Receiver 43
3.3 Transmitting and Receiving Corrections 45
3.3.1 Base Station Configuration 46
3.3.2 Rover Station Configuration 47
3.4 Configuration Notes 47
3.5 ALIGN Heading Master and Remote Configurations 48
3.5.1 Automatic Set Up for Direct-Wire Connection between Master and Rover via
COM2 48
3.5.2 Manual Set Up via COM2 48
3.6 GLIDE 49
3.6.1 Dual-Frequency GLIDE 49
3.6.2 PDP and GLIDE Configurations 49
3.7 STEADYLINE® 50
3.7.1 Maintain 50
3.7.2 Transition 51
3.7.3 Prefer Accuracy 51
3.7.4 UAL 52
3.8 Enabling SBAS Positioning 53
3.9 Enabling NovAtel CORRECT with PPP 53
3.9.1 TerraStar Subscriptions 54
3.9.2 Veripos Subscriptions 55
3.10 RTK ASSIST 55
3.11 Transferring Time Between Receivers 56
3.11.1 GPS to Receiver Time Synchronization 56
3.11.2 Time Definitions 56
3.11.3 Procedures to Transfer Time 57
3.12 Interference Toolkit 61
3.12.1 Monitoring GNSS Signals 61
Example: 61