Chapter 3 OEM7 Receiver Operation
OEM7 Installation and Operation User Manual v1 47
fix position lat lon hgt (enter your own lat, lon, hgt)
log com2 rtcm1002 ontime 1 (for L1 only models)
log com2 rtcm1004 ontime 1 (for L1/L2 models)
log com2 rtcm1010 ontime 1 (for L1 only models)
log com2 rtcm1012 ontime 1 (for L1/L2 models)
log com2 rtcm1006 ontime 10
log com2 rtcm1033 ontime 10
log com2 rtcm1019 ontime 120
log com2 rtcm1020 ontime 120
saveconfig (optional)
NOVATELX
serialconfig com2 9600 N 8 1 N on
interfacemode com2 none novatelx off
fix position lat lon hgt (enter your own lat, lon, hgt)
log com2 novatelxobs ontime 1
saveconfig (optional)
3.3.2 Rover Station Configuration
At the rover station, enter the following commands:
serialconfig [port] baud [parity[databits[stopbits[handshaking[break]]]]]
interfacemode port rx_type tx_type [responses]
saveconfig (optional)
For example, if COM2 was connected to the correction source:
RTK Automated Correction Detection
interfacemode com2 auto none off
RTCM V3
interfacemode com2 rtcmv3 none off
RTCM V3 with GLONASS
interfacemode com2 rtcmv3 none off
NOVATELX
interfacemode com2 NOVATELX none off
3.4 Configuration Notes
For compatibility with other GNSS receivers and to minimize message size, use the standard
form of RTCMV3 corrections shown in the base and rover examples in Transmitting and
To Next Page
