35
Setting
English
8 – 1 – 1 Pairing with foot control
2 5
1
Perform the operation procedure of “5 – 5 Link
function”�
2
Press �
3
Press and hold the two buttons and the pedal of the
foot control shown below simultaneously for
approximately 10 seconds�
4
Pairing is successful when a beep sounds and “OK”
is displayed on the LCD display�
Make sure battery and
icons below are displayed,
and the device is connected�
5
Press twice to end setting mode�
CAUTION
● If pairing cannot be accomplished, replace the batteries with new ones�
● Pairing may not be possible if something is obstructing the signal between the foot control and control unit�
NOTICE
● Paring can be done within 10 minutes after inserting the battery�
To Next Page
Loading...
