To Next Page

To Previous Page

NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM

3. Open a SSH client program (Putty, Tera Term, etc.), connect to the ENVIROMUX by entering the IP address of the

ENVIROMUX.

Note: Make sure your SSH client is a recent version. Older SSH clients will not work with the ENVIROMUX.

4. When prompted for a login, enter “rs232”.

5. When prompted, enter the password you have assigned.

With a successful login you will receive the message “Connected to RS232 port”. You are now ready to send commands

directly to the connected serially controlled device.

Figure 26- Connection to serial device successful

To exit the connection, close the command window.

Other manuals for NTI ENVIROMUX E-2D

Questions and Answers:

Need help?

Do you have a question about the NTI ENVIROMUX E-2D and is the answer not in the manual?

General