NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
57
Figure 60- IP Device Configuration
IP Device Settings Description
Description The description of the IP Device that will be viewed in the Summary page and in the body of alert
messages
IP Address The IP address of the IP Device
Ping Period Enter the frequency in minutes or seconds that the ENVIROMUX should ping the IP Device
Timeout Enter the length of time in seconds to wait for a response to a ping before considering the attempt
a failure
Retries Enter the number of times the ENVIROMUX should ping a non-responsive IP device before
changing its status from normal to alarm and sending an alert
There is no limit to the number of times you can retry to ping (retries), how long to wait for a response (timeout), or how long you
can set it to wait between pings to a device(ping period). These values are up to you.
Under Group Settings, place a checkmark for each group that alert messages should be assigned to. This will determine who will
receive an alert due to a ping failure.
To Next Page
Loading...
Need help?
General
