CNC Operation
en-938821/2 5 - 35
5
Incidents
String not found in selected block
When replacing one string by another, if the string to be replaced is not found in the selected block, the cursor moves
to the #.
Rewrite the string correctly and restart the operation.
Insufficient memory during insertion
If there is insufficient memory during a block insertion operation, the message is displayed:
"MODIFICATION NOT POSSIBLE"
Delete unused programmes (See 5.4.2.3) and restart the operation.
Word format error
If the word format is incorrect when the selected block is being replaced by the block in the dialogue line (See
Programming Manual), the cursor moves to the address of the incorrect word.
Rewrite the word correctly and replace the selected block.
Examples
The following examples illustrate the various functions available for modifying a programme.
Selection of a block in a programme and replacement of a character string
System in edit mode and programme to be modifed not displayed.
Original blocks Modified blocks
%202 %202
(PART NUMBER 486494) (PART NUMBER 487219)
Enter "%202 N0+1". ☞
Display of programme %202 and selection of block N0 (first block) + one line.
Enter "#;6494;7219". ☞
Replacement of string "6494" by string "7219".
To Next Page
Loading...
