CNC Operation
en-938821/2 5 - 39
5
5.4.2.3 Programme Deletion
Requirements
System in edit mode (See 5.4.2.1).
Actions
If the programme to be deleted is not the active programme (selected when the edit mode was entered):
Enter "% [Programme No.]". ☞
Display of the start of the selected programme with the pointer positioned on the first block (programme number).
Enter "- % [Programme No.]" (same number) ☞
Display of the message:
PROGRAM DELETED
Incidents
When the pointer is not positioned on the first block or the specified programme number is not the same as that
displayed, the message:
MODIFICATION NOT POSSIBLE
Restart the procedure.
5.4.2.4 Programme Renaming
Requirements
System in edit mode (See 5.4.2.1).
Actions
If the programme to be renamed is not the active programme:
Enter "% [Programme No.]". ☞
Display of the start of the selected programme with the pointer positioned on the first block (programme number).
Enter "# % [old No.] % [new No.] (Optional comment)". ☞
The programme is displayed with its new number, possibly followed by a comment.
The programme is no longer the active programme.
Incidents
Incorrect programme number
When the old programme number is not the same as the one displayed or a programme with the new number already
exists, the message:
MODIFICATION NOT POSSIBLE
Restart the procedure.
To Next Page
Loading...
