5 - 40 en-938821/2
The pointer was not positioned on the first block
When the pointer is not positioned on the first block, the block which is selected is replaced by "% [old No.] % [new
No.]", altering the programme.
To restore the old block:
Enter "# [old block]". ☞
Restart the procedure.
5.4.2.5 Duplication of a Part Programme
Requirements
System in edit mode (See 5.4.2.1).
Actions
Enter "% [No. of programme to be created]". ☞
Display of the message:
CREATE NEW PROGRAM ? (Y/N): ❚
Confirm creation of the programme ☞
Y
Display of the line:
>% [Programme No.]
Enter "I % [No. of programme to be duplicated]". ☞
Duplication of the programme.
5.4.2.6 Programme Test
The test mode is used to check a part programme in the operating conditions of the machine and system.
The system analyses and executes the programme without moving the axes, which is far quicker than real machining.
The test checks:
- the syntax,
- the compatibility of the programmed instructions with the machine data accessible to the CNC (e.g. movements
within limit travels including application of tool corrections, axes to be moved declared in the system, etc.).
Functions M00 et M01 are not taken into account during the test.
Requirements
Origin shifts entered (See 5.2.1).
No mode being executed. If a mode is being executed, selection of the test mode is only taken into account after an
interruptible block.
Part programme to be tested selected as active progamme (See 5.4.1.2).
To Next Page
Loading...
