en-938821/2 5 - 61
CNC Operation
5
5.5.2 Programmed Interventions
Programmed interventions are planned within a programme to require operator intervention.
5.5.2.1 Machining Stop Function M00 (or M01 if enabled)
After programme execution has been stopped by function M00 (or M01 if enabled), the operator must perform the
planned operation and then restart programme execution.
Actions
Display of the "M00" indicator in place of the "INCYC" indicator in the status window (See 3.1.3).
Spindle rotation stops.
The operator must perform the required operation (a message may be displayed).
Perform the operation.
Restart programme execution by pressing the "CYCLE" button.
The programme continues.
5.5.2.2 Forcing an Intervention by M12
After programme execution has been stopped by function M00 (or M01 if enabled), the operator must perform the
planned operation and then restart programme execution.
Actions
Movement stops at the end of the block.
The "CYHLD" indicator is displayed in the status window (See 3.1.3), the "INCYC" indicator remains displayed.
The axis jog controls on the machine panel are active, the spindle continues to rotate.
The operator must perform the required operation.
Perform the operation (including any jog operations).
Restart programme execution by pressing the "CYCLE" button.
The programme continues.
5.5.2.3 Wait for Report
During certain operations requiring manual intervention (e.g. manual tool changes programmed by M06), the operator
must report the completion of the operation.
Actions
Perform the required operations.
Press the button provided by the OEM to send the report.
The programme continues.
To Next Page
Loading...
