5 - 94 en-938821/2
Incidents
A programme in the memory has the same number as the programme to be loaded
Display in the dialogue window of the message:
part programme exists. Press any key...
Acknowledge the message. ☞
Key
The programme is not loaded.
The part programme memory is full.
The following message is displayed in the dialogue window:
Programme zone full. Press any key...
Acknowledge the message. ☞
Key
The programme is not loaded.
End of the Procedure
Exit from the page. ☞
OUT
Exiting from the page does not interrupt loading in progress.
5.9.6.2 Loading Tool Offsets from the NUM Diskette Drive
!
CAUTION
Do not load new tool offsets when machining is in progress. The new offsets are taken into
account immediately and could cause collision between the tool and the part.
Actions
Select "TOOL OFFSETS". ☞
!
1
The "SERVICE DISKETTE: CORRECTORS" page is displayed with the softkeys:
CD
DIR CD..
HELP
OUT
TRANSF.
CD \
ABORT
and the dialogue line:
Transfer >❚
Press the
HELP
key for help on the softkeys displayed, which are the same as for programme load (See 5.9.6.1).
Commands Already Described
Commands CD.., CD and CD\ are described in 5.9.5.3 and command "DIR" is described in 5.9.5.4.
To Next Page
Loading...
