5 - 96 en-938821/2
5.9.7 Unloading to NUM Diskette Drive
The commands described below are used for dialogue with the drive.
Requirements
Link established with the diskette drive and presence of a serial line configured for the Kermit protocol (see C.2.3).
Drive on.
"Kermit" serial line selected.
The reduced "FILE UNLOADING" menu (See 5.9.3) is displayed.
General Remarks
Data format
The data (part programmes and tool offsets) backed up by the NUM diskette drive have a special format which differs
from that of the other backup modes (load/unload modes, APA10, etc.). This means that the data backed up on the
NUM diskette drive cannot be loaded in the other modes.
Transmission interrupted
If transmission is accidentally interrupted, the backup file is not created. Check that transmission was completed
normally by checking for presence of the backup file by the “DIR” command.
File already exists
!
CAUTION
If a file with the same name as the file to be unloaded already exists on the diskette, it is
overwritten without asking for confirmation.
5.9.7.1 Unloading the Active Programme to the NUM Diskette Drive
Actions
Select "ACTIVE PROGRAMME". ☞
)
0
The "SERVICE DISKETTE: UNLOAD PROGRAMME" page is displayed with the softkeys:
CD
DIR CD..
HELP
OUT
TRANSF.
CD \
ABORT
The following dialogue line is displayed:
Transfer >❚
To Next Page
Loading...
