Ojmar OTS ADVANCE - Software Codes

1_OTS LOCKS OJMAR 27
1.8 SOFTWARE CODES
Each action taken on a lock has a description. This information will be recorded on
the event keys (See Section 4.14.1) when used together with the locks.
The full list of codes is given below.
DESCRIPTION
DESCRIPTION
Client opening
Test from programmer
Client closure
Master subgroup key opening
Occupant key
Cancellation key
Master key opening
Initialisation from programmer
Key rejected: Different installation number
Initialisation from key
Low battery detection
Opening from programmer
Key rejected: Checksum incorrect
Date and time updated from programmer
Time change key
Invalid date and time
Key rejected: Key not valid or not defined
Time set key
Key rejected: Key in use
Service key opening
Automatic opening key
Mechanical fault
Events read from programmer
Key rejected: Key cancelled on blacklist
Events read from key
Master subgroup key closure
No event recorded
Hour back
Automatic opening
Service key closure
Hour on
Key rejected: Outside time zone
Update programmer
Memory deleted with key