Maintenance > 125
5. Lift the right-hand end of the cartridge and then draw the cartridge to the right to
release the left-hand end as shown, and withdraw the toner cartridge out of the MFP.
6. Put the cartridge down gently onto a piece of paper to prevent toner from marking
your furniture.
7. Remove the new cartridge from its box but leave its wrapping material in place for
the moment.
8. Gently shake the new cartridge from end to end several times to loosen and
distribute the toner evenly inside the cartridge.
9. Remove the wrapping material and peel off the adhesive tape from the underside of
the cartridge.
10. Holding the cartridge by its top centre with the coloured lever to the right, lower it
into the printer over the image drum unit from which the old cartridge was removed.
CAUTION!
The green image drum surface is very delicate and light sensitive.
Do not touch it and do not expose it to normal room light for more
than 5 minutes. If the toner cartridges need to be out of the MFP
for longer than this, please lower the top cover. Never expose the
drum to direct sunlight or very bright room lighting.
To Next Page
Loading...
Need help?
General
