Oki MC851+ User Manual

Configuring your machine... > 56
Network
Menu (cont.)
Network
Setup
(cont.)
Subnet Mask xxx.xxx.xxx.xxx Current assigned subnet mask. To
change, proceed as above.
Display condition: TCP/IP protocol
must be enabled.
IP version must be IPv4 or
IPv4+IPv6.
Gateway
Address
xxx.xxx.xxx.xxx Current assigned gateway
address. To change, proceed as
above.
Display condition: TCP/IP protocol
must be enabled.
IP version must be IPv4 or
IPv4+IPv6.
Web Disable, Enable Enables or disables web config.
facility.
Display condition: TCP/IP protocol
must be enabled.
Telnet Disable, Enable Enables or disables Telnet config.
facility.
Display condition: TCP/IP protocol
must be enabled.
FTP Disable, Enable Enables or disables communication
via FTP.
Display condition: TCP/IP protocol
must be enabled.
IPSec Disable, Enable Enable via the web page or
Configuration Tool.
SNMP Disable, Enable Enables or disables SNMP of FTP
(TCP/IP or NetWare).
Display condition: TCP/IP protocol
must be enabled.
Network Scale Small, Normal Normal: Can work effectively even
when connected to a HUB that has
a spanning tree feature. However,
printer start up time gets longer
when computers are connected to
two or three small LANs.
Small: Computers can cover from
two or three small LANs to a large
LAN, but it may not work
effectively when it is connected to
a HUB with a spanning tree
feature.
HUB Link
Setting
Auto Negotiate,
100BASE-TX FULL,
100BASE-TX HALF,
10BASE-T FULL,
10BASE-T HALF
Sets the hub linking method.
Network PS-
Protocol
ASCII, RAW Select PostScript data format for
the network port.
Factory Defaults Execute Select Yes to reload the settings
present when the unit was setup
by the manufacturer.
FEATURE OPTION DESCRIPTION

Oki MC851+ Specifications

General

Brand	Oki
Model	MC851+
Category	All in One Printer
Language	English