Chapter 7: Accessories
7-19
1. Switch off the printer.
2. In order to fit the feet, set the
printer on its left side with
the platen knob pointing up-
wards. The right support
foot is to be fitted first.
3. Hook the corners of the sup-
port foot into the cutouts
provided for this in the bot-
tom of the printer.
4. Press the foot carefully in the
direction of the arrow to-
wards the bottom of the
printer so that its edges line
up with those of the printer.
5. Before fitting the left foot,
temporarily remove the plat-
en knob to avoid damaging
it. Set the printer on its right
side in order to fit the left
support foot in a similar
way.
Cutouts
To Next Page
Loading...
