Chapter 7: Accessories
7-22
Feeding continuous
paper
1. Move the paper lever on the
right of the printer back to
the continuous paper posi-
tion (REAR). The symbol on
the cover for cut sheet han-
dling (TOP) shows you the
correct lever position.
Warning!
Direct pressure on the platen can cause damage to the print
head and pins.
Make sure the paper guide is correctly adjusted.
2. Place a stack of continuous paper underneath the printer or feed
the continuous paper from below through the feed slot of a
printer table.
3. Open the cover of the left
hand sprocket feed, place
the continuous paper onto
the first two sprocket pins
and close the cover again.
To Next Page
Loading...
