Chapter 8: Troubleshooting
8-4
Fault tables
Malfunctions are indicated by the blinking of the ALARM lamp.
The other lamps show the type of fault.
The messages listed point to faults that can generally be remedied
by the user. If the fault message appears again after you have un-
dertaken the remedy described, contact your supplier.
ALARM SEL MENU 10 cpi 15 cpi Description
• - - - - The stock of paper has run out. Top
up with new paper.
• - x The paper lever is set to the cut sheet
symbol (TOP) although continuous
paper is being used. Transport the
continuous paper to the PARK
position or choose another means of
feeding the continuous paper.
• - x A paper jam has occurred. Remove
the paper and make sure the paper
path is free. Press the SEL button.
- x - - The print head, the LF or space
motor became too hot, the printer
automatically reduced its through-
put.
Should the ALARM indicator lamp start blinking, refer to the fol-
lowing table.
If the remedies described are not successfull, contact your supplier.
Faults that can be
remedied by the
user
- status of the indicator lamp
unchanged
• indicator lamp is lit
X indicator lamp is blinking
To Next Page
Loading...
