Appendix C: Bar codes
C-5
Table for Selection of Plain Writing
n
8
Description
0 No plain (uncoded) writing
1 LQ character as plain writing
The character size of plain writing does not depend on the bar code,
it is always set to 12 cpi.
The font of the LQ characters is the same as the font selected for
receiving p
1
data.
Please note that this command does not start the printer.
The basic settings of this command are:
n
1
, n
2
1, 0 UPC-A
n
3
, n
4
0, 9 135/180 inch
n
5
1 1/72 inch
n
6
1 1/72 inch
n
7
1 2,5 : 1
n
8
2LQ
Tables 1 through to 7 are used to calculate the width of the bar code.
If the bar code to be printed extends beyond the right margin of the
printing material, the print command will be ignored.
Please refer to tables 1 and 2 for determining the width of the Codes
EAN, UPC and Code 128. Tables 3 through to 7 are reserved for Code
39 and Interleaved 2/5.
Table 1 shows the ratio between n
5
and the maximum width of a
bar code character in combination with the bar code type.
To Next Page
Loading...
