D-14
Appendix D: Interface Data
Option Action
Parity Is odd or even parity used?
odd parity - select Odd.
even parity - select Even.
no parity - select None.
Serial Data 7 Is the data format used 7 bit or 8 bit?
or 8 Bits 7-bit format - select 7 Bits.
8-bit format - select 8 Bits.
Protocol Which protocol is used?
Ready/Busy Protocol - select Ready/Busy.
X-ON/X-OFF Protocol - select X-ON/X-OFF.
Diagnostic Test Do you want to perform an I/F test?
Yes - select Yes.
Normal printing - select No.
Busy Line Via which line is a Busy signal received?
SSD -9 V - select SSD-.
SSD +9 V - select SSD+.
DTR -9 V - select DTR.
RTS -9 V - select RTS.
Baud Rate Which baud rate (Bit/s, BPS) is used?
19.2000 Baud - select 19200 BPS.
9.600 Baud - select 9600 BPS.
4.800 Baud - select 4800 BPS.
2.400 Baud - select 2400 BPS.
1.200 Baud - select 1200 BPS.
600 Baud - select 600 BPS.
300 Baud - select 300 BPS.
DSR Signal Does your system send a DSR signal to the printer?
Yes - select Valid.
No - select Invalid.
DTR Signal When is a DTR signal sent?
When turning the printer ON-LINE - select
Ready on Select.
When turning the printer on - select
Ready on Power Up.
Busy Time Which pulse duration is required for a Busy-signal?
200 ms - select 200 ms.
1 second - select 1 s.
Menu options for
the serial interfaces
(RS-232C,
RS-422A)
To Next Page
Loading...
