%Setting Top of Form for Single Sheets
Setting Top of Form for Single Sheets
When setting the position on the page where you want the first line of printing to appear, use the
lower red line on the paper shield as a guideline_it shows the baseline of the current printing
position.
1.Press the SELECT button to deselect the printer (SELECT light goes out).
2.To move the paper up, hold down the TOF/PARK button and press FEED. To move the paper
down, hold down the TOF/PARK button and press FONT. This moves the paper in very fine
increments
(1/180-inch), so you can position the location of your first line of print precisely. The amount you
can move the paper using this method is limited to avoid potential paper jams.
3.Press the TOF/PARK button to store your chosen setting permanently in ML380's memory. The
setting will be retained, even when the printer is off, until you reset it.
4.Press the SELECT button to select the printer. The SELECT light will come on.
ML 380 ( 96-02-03 )
To Next Page
Loading...
Need help?
General