To Next Page

To Previous Page

%Double Width

Double Width

Use these commands to produce characters twice as wide as regular characters. They can be used with

any of the character pitches. For example, if the current pitch is 12 cpi, double width characters will print

at 6 cpi. The "Character Width Values" table on page 74 shows all the possible combinations.The

one-line double width commands are especially convenient for titles and headlines, since they turn off the

double width printing automatically at the end of the line. If you want to cancel one-line double width

printing before the line ends, send the command DC4 or ESC W 0. You can also cancel one-line double

width printing with the command LF (see page 92) or ESC ! n (see page 81).

nOTE: The DC4 command will have no effect if you have engaged double width printing with the ESC W

1 or the ESC ! n command; in these cases, only the ESC W 0 or ESC ! n command will cancel double

printing.

You can also use the ESC ! n command (see page 81) or the Menu Select Mode to choose continuous

double width printing.

ML 380 ( 96-02-03 )

Oki Microline ML380 User Manual

Other manuals for Oki Microline ML380