%Skip Over Perforation
Skip Over Perforation
If skip over perforation is set to Yes on the menu, the printer will automatically skip an inch from the
bottom of one page to the top of form on the next page. Use the ESC N n command to change the
number of lines skipped. The actual amount of space skipped between pages varies with the current line
spacing; however, after you've set the skip size, it won't increase or decrease if you change line spacing.
The ESC O command returns the perforation skip to its default.You can also use the ESC @ reset
command (see page 107) to reset the perforation skip to the default. The skip over perforation feature will
interfere with page formatting controlled by software packages such as word processors. If you're using a
package that controls page length directly, you should set the Skip Over Perforation item in the menu to
OFF.Note
ML 380 ( 96-02-03 )
To Next Page
Loading...
Need help?
General