%Loading Rear Feed Paper
Loading Rear Feed Paper
The tractor feed mechanism for use with continuous-form paper is located at the rear of the printer.
If you wish to load continuous-form paper from the bottom of the printer, you will need to
purchase and install the optional pull tractor: see page 33.
1.Although it's not necessary to do so, it's easier to install continuous-form paper from the rear if
you first remove the paper separator.
2.Make sure the paper selection lever is forward.
3.Release the tractor lock levers by pulling up on them. Slide the tractors to position them for your
paper width. The movement of the left tractor is limited, so you'll need to use the right tractor for
any large adjustments in width.
4.Open the tractor covers and place the sprocket holes on either side of the paper over the tractor
pins. Close the tractor covers.
ML 380 ( 96-02-03 )
To Next Page
Loading...
Need help?
General