%Form Length
Form Length
You can specify the form length in either inches or lines. If you will most often be using one of the
standard page lengths listed on the menu, we recommend that you use the Menu Select Mode to set a
default form length, and then use one of the form length commands whenever you want to change it
temporarily.When you use either of these commands to change the form length, the skip over perforation
setting returns to the menu default (0) and the top of form is set at the current print position.When setting
the form length by lines, remember that the actual depth of the form in inches will depend on the current
line spacing.
ML 380 ( 96-02-03 )
To Next Page
Loading...
