Oki Microline ML380 - Cut Sheet Feeder Control

%Cut Sheet Feeder Control
Cut Sheet Feeder Control
The following commands are active only when the Cut Sheet Feeder accessory is installed on the printer.
Use the ESC EM I command to feed a sheet of paper from the cut sheet feeder to the top of form
position. If paper is already in the printer, the printer will eject the page and load another sheet. Any data
that is in the print buffer when this command is received will print before the paper is ejected and
replaced.The ESC EM R command instructs ML380 to print the data in the print buffer and eject the
page. A line feed code (see page 92) at the end of the page causes the next page to feed into the printer
automatically.
Bit-Image Graphics
ML 380 ( 96-02-03 )