Okolab LEO - Page 83

79
Figure 108. T1 Calibration: start multi-point calibration (a – b - c).
8. When you finish the calibration, an overview appears as in Figure 109. Click on Save to complete the
calibration or Cancel to undo.
Figure 109. T1 Multi Point Calibration.
14.3 Factory Calibration
Press Factory Reset icon to cancel the last user temperature calibration and restore the factory values
(see Figure 110 a). If you are sure of the reset, press OK, as shown in Figure 110 b.
36.8
2
ba
c
36.8
1
2
25.00
30.00
37.00
40.00
50.00